Talaria Mx3/Mx4 Carbon Fiber Wrap Kit

Carbon fiber cut-outs for every plastic piece on the Talaria Mx3 and Mx4. The weave shifts visually depending on the angle you look at it from, which is the part hydro-dipped carbon never gets right. Buy it as a full kit or pick up single pieces.

Fitment

• Talaria Mx3
• Talaria Mx4

This kit does not fit the Talaria Mx5 or the Talaria XXX. Talaria plastics are not shared across models - check which Talaria you have before ordering.

Options

Part - the full kit covers all five pieces below, or buy any one on its own:

• Battery Lid - the largest cut-out in the kit
• Rear Seat Fender
• Rear Wheel Fender
• Motor Cover
• Ignition

Colour

• Carbon Fiber
• ShadowSlate Camo

This is a DIY product - read before ordering

This is vinyl, not a decal or a sticker. Pieces arrive as squares. You heat the vinyl to activate the adhesive and pull it over each plastic to stick.

• Pieces are not labelled, so the wrap surface stays undamaged - match each piece to its part by size.
• Bolt holes must be poked through with a knife or sharp point so the plastics can be threaded back onto the bike.
• Trimming and tracing the edges with a razor after the wrap is on the plastic is strongly recommended.

You will also need to cut openings for the Talaria emblem on the motor cover and the key slot on the ignition.