Surron Ultra Bee Carbon Fiber Wrap Kit

Carbon fiber cut-outs for every plastic piece on the Surron Ultra Bee. The weave shifts visually depending on the angle you look at it from, which is the part hydro-dipped carbon never gets right. Buy it as a full kit or pick up single pieces.

Fitment

• Surron Ultra Bee

This kit does not fit the Surron LBX / Light Bee. The two bikes share almost no bodywork - if you have an LBX, use the Surron LBX kit instead.

Options

Part - the full kit covers all six pieces below, or buy any one on its own:

• Front Fender
• Rear Fender
• Battery Lid Sides
• Side Frame Covers
• Bashguard Side Covers
• Fork Guards

Colour

• Carbon Fiber
• ShadowSlate Camo

This is a DIY product - read before ordering

This is vinyl, not a decal or a sticker. Pieces arrive as squares. You heat the vinyl to activate the adhesive and pull it over each plastic to stick.

• Pieces are not labelled, so the wrap surface stays undamaged - match each piece to its part by size.
• Bolt holes must be poked through with a knife or sharp point so the plastics can be threaded back onto the bike.
• Trimming the edges after the wrap is on the plastic is strongly recommended, and is what gets you the finish shown in the photos.