Talaria XXX Carbon Fiber Wrap Kit

Carbon fiber cut-outs for every plastic piece on the Talaria XXX. The weave shifts visually depending on the angle you look at it from, which is the part hydro-dipped carbon never gets right. Buy it as a full kit or pick up single pieces.

Fitment

• Talaria XXX

Talaria plastics are not shared across the XXX, Mx3, Mx4 and Mx5. This kit is cut for the XXX only. If you have an Mx3 or Mx4, use the Talaria Mx3/Mx4 kit instead.

Options

Part - the full kit covers all five pieces below, or buy any one on its own:

• Side Panel
• Motor cover / Side Panel - the largest cut-out in the kit
• Ignition
• Horn cover
• Rear Fender

Colour

• Carbon Fiber
• ShadowSlate Camo

This is a DIY product - read before ordering

This is vinyl, not a decal or a sticker. Pieces arrive as squares. You heat the vinyl to activate the adhesive and pull it over each plastic to stick.

• Pieces are not labelled, so the wrap surface stays undamaged - match each piece to its part by size.
• Bolt holes must be poked through with a knife or sharp point so the plastics can be threaded back onto the bike.
• Trimming the edges after the wrap is on the plastic is strongly recommended.

You will also need to cut openings for: the ignition button, the horn hole on the horn cover, the bottom section of the rear fender, and the charging hole on the motor cover / side panel.