Surron LBX Carbon Fiber Wrap Kit

Carbon fiber cut-outs for the plastics on the Surron LBX. The weave shifts visually depending on the angle you look at it from, which is the part hydro-dipped carbon never gets right. Buy it as a full kit or pick up single pieces.

Fitment

• Surron LBX / Light Bee X

This kit does not fit the Surron Ultra Bee. The two bikes share almost no bodywork - if you have an Ultra Bee, use the Ultra Bee kit instead.

What's in the full kit

The full kit covers the following LBX pieces:

• Battery lid
• Side battery cover
• Back battery plastic
• Rear seat fender
• Rear wheel fender
• Under seat tray
• Ignition

Sold individually

If you only want one piece, these are the parts available on their own:

• Battery Lid
• Rear Seat fender
• Rear Wheel fender
• Ignition

Colours

• Carbon Fiber
• White Carbon Fiber
• ShadowSlate Camo
• White

This is a DIY product - read before ordering

This is vinyl, not a decal or a sticker. Pieces arrive as squares. You heat the vinyl to activate the adhesive and pull it over each plastic to stick.

• Pieces are not labelled, so the wrap surface stays undamaged - match each piece to its part by size.
• Bolt holes must be poked through with a knife or sharp point so the plastics can be threaded back onto the bike.
• Trimming the edges after the wrap is on the plastic is strongly recommended.

You will also need to cut openings for the bottom section of the rear fender, the display hole on the battery lid, and the key slot on the ignition.